User manual

Working with the notebook
Setting up the port replicator
Select a suitable location for the Port Replicator before setting it up.
Follow the instructions below when doing so:
• Never place the port replicator on a soft surface (e.g. c arpeting, upholstered furniture, bed).
This can block the air vents of the notebook and cause overheating and damage.
• Place the port replicator on a stable, flat and non-slip surface. Please note that the
port replicator’s rubber feet may mark certain types of surface.
• Never place the port replicator and the m a ins adapter on a heat-sensitive surface.
• Do not expose the port replicator to extreme e nvironmental conditions.
Protect the port replicator from dust, humidity and heat.
Connecting the mains adapter to the P ort Replicator
3
1
2
► Connect the power cable to the
mains adapter (1).
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the DC
jack (DC IN) of the Port R eplicator (3).
When the notebook is connected to a Port Replicator, the operating system crea tes
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is conne cted to a Port Replicator of the same type.
Fujitsu 59