User manual

Connecting e xtern a l devices
USB port with charging function (Anytime U SB charge)
You can use this USB port to charge or supply power to a connected USB device (e.g.
to charge a P DA or a mobile phone or to connect a USB lamp).
This is also possible when the Notebo ok laptop is switched o ff, if in the BIOS- Setup-Utility
(BIOS: basic input-out put system) in the menu Advanced - Miscellaneous Configurations
the functi on Anytime USB Charge is activated. If the setting AC is selected, the device
will only be charged when the mains adapter is connected.
Please refer to section "
Settings in BIOS Setup Utility", Page 87 for a description
of how to call up and operate the BIOS-Setup-Utility.
USBchargingfunction
It is recommended that the notebook be operated with the po wer supply connected
whenever the USB port with charging function is in use, as this function will drain
the battery more quickly if an external USB device is being charged.
The power supply unit must already be connected when the notebook is
switched off, as otherwise the USB charging function will be disabled and
the connected USB devices will not be charged.
Some USB devices (e.g. mobile telephones) require a driver in order to utilise the
USB charging function. In this case the USB c harging function will not work when th e
notebook is switche d off, as no drivers are active when the notebook is switched off.
► Connect the data cable to the
external device.
► Connect the data cable to a USB port
(Anytime USB charge) of the notebook.
How to remove USB devices correctly
Always co
rrectly remove the device according to the rules described below,
to ensure
that none of your data is lost.
► Left click on the ico n to safely remove hardware, located in the taskbar.
► Select
the device which you want to shut dow n and remove.
► Press the Enter key.

Wait f
or the dialogue box which tells you that it is now safe to remove the device.
Fujitsu 75