User manual

Removing and installing components
during servicing
Installing and removing memory
expansion
MemorymoduleMainmemoryRemovingmemorySystemexpansionSystem expansion
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion y ourself, proceed as follows:
Please observe the safety information in chapter "Im portant notes", Page 12.
When installing/removing memory modules, the battery must be removed from
the notebook and the n otebook must not be connected to the power supply,
see "
Preparing to remove com ponents", Page 78.
Only use memory expansion modules that have been approved for your
notebook (see "
Technical data", Page 99).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension c ompartment.
You must open the service compartm ent to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. T heref ore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend th at you wait one hour after switching off the notebook before removing
or installing memory modu les. Otherwise, there is a risk of suffering burns!
As some compone nts are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on inst alling and removing boards and components", Page 77.
80 Fujitsu