Operation Manual

Security functions
Switch on the device using SystemLock
If you have an internal SmartCard reader, you can switch on the device by inserting the SmartCard.
If you switch on the device with the On/Off switch then the following m essa ge appears:
Insert a SmartCard.
SystemLock
► In sert your SmartCard.

Enter PIN:
► Enter your PIN.

When the following appears:
• ACCESS DENIED = You have entered an incorrect PIN. After three failed attempts, the
SmartCard will be blocked and can only be enabled again by e ntering the PUK.

Depending on the rights assigned to your SmartCard, you can select the following
functions when this message is displayed on the screen:
F2=Setup, F3=Change PIN
If your SmartCard has the appropriate rights, you can:
F2,function keyF3,func tionkey
F2
: start BIOS Setup.
F3
: change PIN.
If you do not select a function, the system will boot up.
Start B IOS Setup
F2
A SmartCard with the app ropriate rig
hts must be inserted (SuperUser, Service or Admin).
Changing PIN
It is possible to change the PIN for any initialised SmartCard.
► Press the function key
F3
.
► Ente r the old PIN.
► Ente r t he new PIN.
A number with 4 to 8-digits is acceptable for the new P IN. For security
reasons, we recommend tha t you change the PIN for every SmartCard,
and use an 8-digit number each t ime.
► Confirm the new PIN.
Uninstall SystemLock
► Start the device.
Uninstalling
► F ollow the instructions given in section "Carrying out administrator functio ns",
Page 9 1. Se lect "Uninstall" to uninstall SystemLock. You can now use the
device again without the need for a SmartCard.
94 Fujitsu Tech nology Solutions