Operation Manual

Security functions
Error messages
Errormessages
In this chapter you will find the error messages which are generated by the
mainboard and the SmartCard reader.
Error Cause
Boot access denied
The SmartCard has no access rights to the system.
Check your
SmartCard
The SmartCard is either inserted incorrectly or it is not a suitable SystemLock
SmartCard.
SmartCard reader
FAI LURE
An error has occurred on the serial port to the SmartCard reader. If this error
occurs frequently, the connection between the SmartCard reader and the
mainboard must b e checked, or the SmartCard reader must be replaced .
While the error is present, access to the system is blocked.
Non-authorised
SmartCard
The SmartCard cannot be used on this device. The SmartCard has been
configured for a different device.
SystemLock
installation
FAI LED:
An error occurred while installing SystemLock. D o not switch off the device,
insert the "BIOS Flash diskette" instead.
Perform a BIOS update and try the installation p rocess again.
The SmartCard is
blocked.
Enter the PUK:
Yo u have exceeded the maximum allowed number of incorrect PIN entries.
The SmartCa rd is blocked. Enter the administra tor PUK to re-activate the
SmartCard. You must then enter a new User PIN to restart the system.
Using the security functi
on of the tablet keys
If you have assigned a superviso r password and/or user password in the form of
a combination of tablet button presses, as described below, you can enter this
via the tablet buttons when starting your device.
Setting the Superv isor password
► Select Start - Run.
► Enter the following at the command line: C:\Program Files\Fujitsu\Security
Panel Application\Supervisor\FJSECS.EXE.
► Confirm with
Enter
.
► Follow the i nstructions on the scree n.
Setting the User passwo
rd
► Select Start - All Programs.
► Select Security P a nel Ap
plication – Security Panel Application.
► Follow the i nstructions on the scree n.
Fujitsu Technology Solutions 95