Operation Manual

Troubleshooting and tips
Using the reset key
If the device is no longer responding and no longer responds to th e on/off
switch, use the reset key to switch the device off.
► D isconnect the device from the mains adapter.
► Push a pen or a piece of wire (such as a paperclip) firm ly into the opening of
the reset key to switch the system off.
► C onnect the mains adapter to the device again.
► Switch the device on again.
Restoring the hard disk
contents under Windows
Harddisk:Operatingsystem,restoring
To perform the following steps, you must connect an external optical
drive (available as an option) to the device.
You can use the "W ind
ows Recovery C D" (optionally available) and the "Drivers & Utilities
CD/DVD" to reinsta
ll the operating system.
The instructions a
re p rovided on the c ase of the Recovery CD.
During the reinst
all process your personal files and any installed programs
will be deleted.
We advise yo u to ba ckup your files to an external hard
drive, or CD / D V
D disk before you start.
► Switch the notebook on.

The following display briefly appears on the screen during start-up:
<ESC>Diagnostic screen <F12>Boot Menu <F2>BIOS Setup
► When this message appears, press the function key
F12
.
► Insert the "Windows Re covery CD" into the optical drive.
► Select CD-ROM and press the Enter key.
► Follow the instructions on the screen.
After the installation you must install all the drivers again. Some installed hardware
components will not be correctly supported until this has been done.
► In sert the "Drivers & Utilities" CD/DVD into the optical drive. The CD starts aut omatically.
► Click on the Desk Update button.
► Select Automatic driver installation (Express) and click on Start installation.
► Follow the instructions on the screen.
► R esta rt your notebook when the driver installation is completed.
48 Fujitsu