Operation Manual

Troubleshooting and tips
The radio connection to a networ
kdoesnotwork
Theradioconn ectiontoa networkdoes notwork
Cause Troubleshooting
The wireless component is disa
bled.
► Switch the radio component on (see
"
Switch ing th e wireless components on and
off", Page 36).
The wireless component is enabled. De sp ite
this, the wireless connection to a network does
not work.
► Ch eck whether the radio connection is
switched on via the software.
► Further information on using the radio
component can be found in the help files.
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A be e p sounds every few seconds.
The battery is almost flat.
► Ch arge the battery.
Error messages on the screen
Errormessageso
nthescreen
Errormessage:
This section describes the erro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, des pite troubleshooting measures, please
contact the place of purchase or o ur customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is flat.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Pre ss the function key
F2
to access the
BIOS Setup.
► In the BIOS Setup , select the Exit menu.
► Select the entry Loa d Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory a n error has
resulted at the address x xxx.
► Check w
hether the additional memory
module
has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Star
ttheBIOS Setup (Primary Master
subm
enu) and select the correct settings.
52 Fujitsu