Operation Manual

Troubleshooting and tips
The radio connection to a networ
kdoesnotwork
Theradioconn ectiontoa networkdoes notwork
Cause Troubleshooting
The wireless component is disa
bled.
Switch the radio component on (see
"
Switch ing th e wireless components on and
off", Page 35).
The wireless component is enabled. Despite
this, the wireless connection to a n etwork does
not work.
Check whether the radio connection is
switched on via the software.
Further information on using the radio
component can be found in the help les.
Error messages on the sc
reen
Errormessages onthescr eenErrormessage:
This section describes the erro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or o ur customer service centre.
Error message/cause Resolution
CMOS ba ttery bad
If the error message occurs repeatedly, the
buffer battery in the no tebook is at.
Contact your sale
s outlet or our customer
service centre.
System CMOS checksum bad - default congura tion
used
The system conguration information is
incorrect.
Switch the note
book off.
Switch the notebook on.
Press the func
tion key
F2
to access the
BIOS Setup.
In the BIOS Setu p, select the Exit menu.
Select the e
ntry Loa d Setup Defaults.
Select OK and press the En ter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory a n error has
resulted at the address xxxx.
Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
Switch the n otebook off with the ON/OFF
switch.
Wait 3 - 5 seconds and switch on the
notebook aga in.
Keyboard error
If you are using an external keyboard:
Check the connection and reboot the
notebook.
58 Fujitsu