Operation Manual

Working with the noteb ook
Connecting the mains adapter to the Port R eplicator
3
1
2
► Connect the mains cable to the
mains ad apter (1).
► Plug the power cable into the mains
socket (2).
► Connect the m ains adap ter cable to the DC
jack (DC IN) of the Po rt Replicator (3).
When the no tebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. Th is profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/OFF switch on the port
replicator to switch the notebook on.

The power-on i ndicator of the Port
Replicator lights up.
Switching off notebook via Port Replicator
► Close all applications and shut down your op erating system (please refer
to th e manual for the operating system).
If the notebook cannot be shut down properly, press the ON/OFF button
on th e Port R eplicator for approx. four seconds. The notebook will switch
off. Any unsaved data may however be lost.
38 Fujitsu