User's Manual

Appendix/Index
157
■ Overseas use
● Cannot use the terminal even when is displayed
overseas.
Do you subscribe to WORLD WING? Check if you
subscribe to WORLD WING.
● is displayed, and you cannot use the terminal
overseas.
• Are you out of the international roaming service area or
in an area with poor signal strength? Check if the
service area and network operator are available,
referring to NTT DOCOMO website.
• Change network mode type to [LTE/3G/GSM(Auto)]. →
P149
• Set the network operator to [Choose automatically]. →
P149
• It may be recovered by turning the terminal OFF and
ON.
→ P32
● Cannot use the terminal suddenly while using overseas.
Does usage amount exceed the limit of maximum charges
for use? For use of International roaming (WORLD WING),
the limit of maximum charges for use is set in advance.
When it exceeds the limit of maximum charges for use,
pay the charges.
● There is no incoming call overseas.
Is Restricting incoming calls set to [Activate restriction]? →
P151
● No caller ID is notified/A notified caller ID is different
from that of the caller/Functions for using contents
saved in the phonebook or those using Caller ID
notification do not operate.
Even when a caller notifies its caller ID, it is not displayed
on the terminal unless notified from the network or
network operator used. And, a notified caller ID may be
different from that of the caller by some networks or
network operators you use.
● Cannot perform data communication overseas.
Check the data roaming settings. → P148
■ Data management
● Data saved in microSD card is not displayed.
Reattach the microSD card. → P137
● Data transfer is not performed.
Do you use USB HUB? If you use USB HUB, operations
may not be performed correctly.
● [No thumbnail] appears when displaying images/Gray
frame appears in the image list.
[No thumbnail] or a gray frame may appear if image data
is broken.
■ Bluetooth
● The terminal cannot be connected to a Bluetooth device/
A Bluetooth communication device cannot be found
from the terminal.
Make Bluetooth device (commercially available)
detectable and then register the device on the terminal. If
you delete already registered device and register the
device again as a new device, delete the registrations on
both the terminal and Bluetooth device (commercially
available), and then perform registration of the devices.