User's Manual

Before using the terminal
28
◆ Installing/Removing a docomo nano
UIM card
･ Install/remove after turning OFF the power.
･ Be sure to use the tray when inserting a docomo nano UIM
card. Failure to do so may cause a malfunction.
■ Installing
a Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip (
a )
･ Opening the slot cap reveals microSD card slot on the
back side and docomo nano UIM card slot on the display
side of the terminal. Make sure of position and
orientation when inserting.
b Put your fingertip on the tab of the tray and pull it straight
out (
b )
･ The tray is designed to be removed from the docomo
nano UIM card slot.
c With the IC side facing up, place the docomo nano UIM
card on the tray (
c )
･ Check the orientation of docomo nano UIM card corner
cut.
d Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot (
d )
e Press firmly the slot cap of the terminal to close → P22
■ Removing
a Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip
b Put your fingertip on the tab of the tray, pull it straight out,
then remove the docomo nano UIM card
c Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot
d Press firmly the slot cap of the terminal to close → P22
docomo nano UIM cardmicroSD card
a
c
d
b
IC
Corner cut
Tray
Cut
Slot cap