User's Manual

Before using the terminal
46
✔ INFORMATION
･ When no operation is performed in a certain period of time,
the screen automatically turns off according to the settings of
"Screen timeout" (
→ P106) and the terminal turns into sleep
mode.
･ When receiving a call in sleep mode, sleep mode is
deactivated.
◆ Unlocking screen lock
1
During sleep mode, press P /fingerprint sensor
2
On the screen, tap
The lock is canceled.
･ Depending on the security unlock setting (→P118),
authentication is required on the lock screen after
swiping.
･ Tap on the lock screen to activate the camera.
･ Tap on the lock screen to activate the しゃべってコン
シェル (Shabette concier).
✔ INFORMATION
･ By default, numbers of missed calls and unread docomo
mails are shown even when lock screen is displayed.
･ By default, the lock screen goes into the sleep mode after
approximately 10 seconds.
◆ Slide-in function
By default, you can call out Slide-in launcher and Capture &
Draw/Highlight & Copy by sliding your finger from the slide
spot (start point for sliding) at the corner of the screen.
･ For information about the settings of the Slide-in function,
refer to "Slide-in function".→P130
❖ Slide-in launcher
Activate an application from a shortcut saved in Slide-in
launcher.
1
Slide your finger from the slide spot to the
center of the screen, then release the finger at
a shortcut in Slide-in launcher
･ By default, Slide-in launcher is set in the slide spot at the
lower left of the screen.
･ You can set the Slide-in function by releasing your
finger at the position of , which is called up at the
same time as the Slide-in launcher.
2
Perform target operations
" ひつじのしつじくん
®
(Butler Sheep)"
©
NTT DOCOMO