Owners manual

185
8.1 Scanner Settings
8
SCANNER SETTINGS
*1: Depending on the "PART NO." on the product label, the factory default setting differs as follows:
For details about product labels, refer to
“6.5 Labels on the Scanner” on page 157.
Item Explanation Selectable parameter Default
Sheet count
(Consumables
counter)
For evaluating the consumable replace-
ment cycle or cleaning cycle.
Use this function to reset the counters
after replacing consumables or the
cleaning.
Refer to “5.1 Consumables and
Replacement Cycle” on page 122.
After Cleaning/Pad/Pick roller/Sepa-
rator Roller/Brake roller/Remaining
ink level (only for the imprinter
option)
-
Power saving Select the waiting time before entering
the Power saving mode.
Refer to “8.2 Power saving setting”
on page 190.
Setting range 15 to 55 minutes (set in
steps of 5 min.)
15 min.
Power off after a certain period of
time: Select to have the scanner turn
off automatically when it is turned on
and left unused for a certain period of
time. Also, specify the time until
power-off.
Refer to “8.2 Power saving setting”
on page 190.
[Power off after a certain period of
time] check box
(*1)
1 Hour/2 Hours/4 Hours/8 Hours
(when the above check box is
selected)
Offset setting Adjust the start position for the docu-
ment scanning.
Refer to “8.3 Offset/Scan scale” on
page 191.
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
left right
0mm
up down
0mm
Vertical magnifi-
cation Adjustment
Adjust the magnification in the feed-
ing direction.
Refer to “8.3 Offset/Scan scale” on
page 191.
Setting range -6.3% to 6.3% (set in
0.1% steps)
0%
PART NO. Default
PAxxxxx-Bxx1 Selected / 4 Hours
PAxxxxx-Bxx2 /Bxx3 /Bxx5 /Bxx7 Not selected