Owners manual

190

8.2 Power saving setting

When not using this scanner for a certain time, it will enter automatically the power saving mode.

Configure the Power saving mode as follows:

1. Start up the Software Operation Panel.

Refer to “8.1 Scanner Settings” on page 175.

2. Select [Device Setting] from left side list in the window.

3. Use the slide control bar to set the waiting time before entering the power

saving mode.

Setting range 15 - 55 minutes. (Set in steps of 5 minutes)

HINT

When you select the [Power off after a certain period of time] check box, the

scanner will turn itself off automatically if it is turned on and left unused for

the set time. The time until power-off can be selected from 1/2/4/8 hours.