Owners manual

Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
172
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Item Description Setting/Value Factory Default SCSI or USB
Connector 1
SCSI or USB
Connector 2
3: Configurable
Page Counter Check the replacement cycle of
the consumables and the total
page count of the maintenance
parts.
Also use it to reset the counter
when you have replaced the
consumables or performed
cleaning.
Total Page Count(ADF) / After cleaning /
Brake Roller / Pick Roller / Separator
Roller / Assist Roller
0
33
Ink Level:Front / Ink Level:Back
(only when imprinter is installed)
Only displayed
when imprinter is
installed
Power saving Specify the waiting time before
entering power saving mode.
Range: 5 min. to 235 min. (in increments of
5 min.)
15 min.
33
Offset Setting Adjust the position to start
scanning for the specified
scanning side(s).
SCSI or USB Connector 1:
ADF(Front) / ADF(Back)
SCSI or USB Connector 2:
ADF(Back)
Main/Sub: -2 to 3 mm
(in increments of 0.5 mm)
Main/Sub: 0 mm
33
Vertical
magnification
Adjustment
Adjust the magnification level in
feeding direction for the specified
scanning method.
Applied to: ADF
Setting range: -3.1 to 3.1% (in increments
of 0.1%)
0%
33