Owners manual

Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
180
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Paper Protection
Sensitivity
You can specify the level of
sensitivity to detect an abnormal
feeding of documents when Paper
Protection is enabled.
It can also be configured from the
operator panel. Note that you can
prioritize the operator panel setting.
Low / Normal / High Normal
33
Scan Setting for
Document with Tab
(Automatic Page
Size Detection)
For documents with index tabs or
index stickers attached on the
bottom of the page, you can keep
the tab (index or index stickers) on
the scanned image when scanning
in Automatic Page Size Detection.
Specifying [Document with tab]
shows the image of the tab, but
slows down the scanning speed.
SCSI or USB Connector 1:
Document with tab / Document without
tab / Non-rectangular document
SCSI or USB Connector 2:
Document with tab / Document without
tab
Document
without tab
33
Scan Setting for
Document in Dark
Background Color
Configure this setting when the
edges of a document with dark
background color are falsely
detected. You can specify the level
of sensitivity to accurately detect the
edges of documents with dark
backgrounds.
Enable / Disable
Density of background color: Level 1 to 5
Disable -
3
Overcrop/
Undercrop
Adjust the size of the scanned
document output image detected in
Automatic Page Size Detection.
Overcrop: 0 to 5 mm
(in increments of 1 mm)
Undercrop: -5 to 0 mm
(in increments of 1 mm)
0 mm -
3
Item Description Setting/Value Factory Default SCSI or USB
Connector 1
SCSI or USB
Connector 2
3: Configurable
-: Not configurable