Owners manual

Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
184
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
■ Message for consumable replacement/cleaning
The following may sometimes appear while using the scanner:
According to the instruction displayed, clean the scanner or
replace the consumables.
When you click the [Ignore] button, the cleaning instruction
disappears and the scanning continues. You may be able to
continue scanning for a while, however, it is recommended
that you replace the consumable(s) as soon as possible.
To stop the scan and replace the consumable(s) right away,
click the [Cancel] button.
For information on how to replace the consumables, refer to
the following sections:
z Pick Roller "7.2 Replacing the Pick Roller" (page 132)
z Separator Roller "7.3 Replacing the Separator Roller" (page 134)
z Brake Roller "7.4 Replacing the Brake Roller" (page 137)
For information on how to clean the scanner, refer to "Chapter
6 Daily Care" (page 118).
Specifying the Cycle to Clean the Scanner
[Cleaning Cycle]
You can specify the cleaning cycle for the scanner.
The background color of the counter changes to yellow when
the page count after cleaning reaches 100% of the value
specified here.
You can also display the message for cleaning (page 184).
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 170).
2 From the listing on the left, select [Device Setting 2] J
[Cleaning Cycle].
3 Specify a value to determine when to clean the scanner.
The specifiable value is from 1,000 to 255,000 in increments of 1,000.
Also specify whether or not to display the cleaning message.
Consumable replacement message:
Cleaning message: