Owners manual

Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
210
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Specifying the Area to Detect Multifeed
[Document check area specification for Multifeed
Detection]
The following setting is only available when you specified
[Check Overlapping (Ultrasonic)].
1 From the listing on the left, click [Device Setting 2] J
[Document check area specification for Multifeed
Detection].
Select the [Selected range] check box in the dialog box.
2 Specify the detection range.
Range Description
Selected range Select the check box to specify the
detection range (colored in light blue) in the
picture below.
Select the check box to enable the setting
in this window. Clear the check box to
disable the setting. Clearing this check box
sets both the start and the end positions to
"0", making the whole document to be
detected for multifeeds.
The above condition applies when the
document is set to the center of the pick
roller width.
Disable
(Left/Middle/Right)
Does not detect multifeeds for the selected
area.
Enable
(Left/Middle/Right)
Detects multifeeds for the selected area.
Start
(Left/Middle/Right)
Displays the starting point of the detection
by the length from the leading edge of the
document.
Configurable area: 0 to 510 mm (in
increments of 2 mm), Start < End
35
35
35
60 60
Feeding direction
Unit: mm
Detected
Sheet
Left
Middle
Right