Owners manual

Index

Appendix

Chapter 1 Scanner Overview

Glossary

Introduction

Contents

TOP

How to Load

Documents

Configuring

the Scan

Settings

How to Use

the Operator

Panel

Various Ways

to Scan

Daily Care

Troubleshooting

Operational

Settings

Replacing

Consumables

Scanner

Overview

How to Fix the Stacker Height

Highly deformed (curled, folded or creased) documents may

be scattered in the output when they are ejected onto the

stacker. In that case, having the stacker height fixed during

scanning may help the documents be stacked neatly.

1 If the scanner driver’s setup dialog box is displayed, close

the dialog box.

2 In the [Main Menu] of the operator panel, select [2: Fixed]

for [9: Stacker Positioning].

For details about the settings, refer to "4.2 Main Menu" (page 65).

D The stacker height is fixed.

z When the scanner has just been powered on, it is set

to [1: Movable].

z In the rear ends of the stacker, a sensor is mounted on

each side which detects documents. Make sure that

nothing is placed in a location (between the two

sensors) that may block the sensor.

z The stacker may move just after turning the power on

or when the scanning starts. Do not touch or place

anything on top.

Sensor