User Guide
Table Of Contents
- How to Use This Manual
- Introduction
- Conventions
- Contents
- Chapter 1 Scanner Overview
- Chapter 2 How to Scan Documents
- Chapter 3 Configuring the Scan Settings
- Chapter 4 Various Ways to Scan
- Chapter 5 Daily Care
- Chapter 6 Troubleshooting
- 6.1 Troubleshooting
- Scanner cannot be powered ON.
- The power LED goes off.
- Scanning does not start.
- Scanning takes a long time.
- Image quality is poor when scanning pictures/photos in black & white.
- Quality of scanned text or lines is unsatisfactory.
- Images are distorted or not clear.
- Vertical streaks appear on the scanned image.
- The power LED flashes after power-on.
- A shadow appears at the top or the bottom of the scanned image.
- Images scanned in black & white (or in grayscale or color) are dark.
- Automatic page size detection fails.
- 6.2 Before You Contact the Scanner Service Provider
- 6.3 Checking the Product Labels
- 6.1 Troubleshooting
- Chapter 7 Operational Settings
- Appendix
- Glossary
- Index
Chapter 7 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
63
How to Scan
Documents
Configuring the
Scan Settings
Various Ways to
Scan
Daily Care
Troubleshooting
Scanner
Overview
Operational
Settings
Resetting the Password
In case you forgot your password, it can be reset in the
following procedure.
1 Right-click the Software Operation Panel icon in the
notification area, and select [Password Setting] from the
menu.
The [Password setting] dialog box appears.
2 Enter the default password which is "fi-scanner", and click
the [OK] button.
The [Password setting] dialog box appears.
3 Enter a new password then again to confirm, and click the
[OK] button.
Up to 32 characters can be used for the password.
Note that only alphanumeric characters (a to z, A to Z, 0 to 9) are
allowed.
A confirmation message appears.
4 Click the [OK] button.
The password is set.