Server User Manual

U41243-J-Z156-1-76 37
Preparation for use and operation Switching the server on and off
4.2 Switching the server on and off
V CAUTION!
If after switching on the server there is nothing but flickering stripes on
the screen, switch the server off immediately (see the chapter “Trouble-
shooting and tips” on page 75, section “Flickering stripes on the monitor
screen” on page 77).
The ON/OFF button does not disconnect the server from the line voltage.
To disconnect from the line voltage completely, remove the power plug
from the power outlet.
Server is switched off
Ê Press the ON/OFF button.
The server switches on, performs the Power-ON Self-Test (POST) after a few
seconds, and starts the operating system.
Server is switched on
Ê Shut down the operating system in an orderly manner.
Ê Press the ON/OFF button.
The server switches off.
Other ON/OFF possibilities
In addition to using the ON/OFF button, the server can also be switched on/off
in the following ways:
– Specified switch-on/switch-off time
The time at which the server switches on or off is set in the ServerView
program.
– Ring indicator
The server is switched on via an internal or external modem. The key switch
must be in the Remote position.
– Following a power failure
The server automatically reboots following a power failure.