Surge Protector User Manual

7
Drive1 Submenu of the Main Menu
The Drive1 submenu allows you to configure secondary ATA devices.
Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads
and sectors may also be displayed.
Figure 3. Drive1 Submenu
Table 3: Fields, Options and Defaults for the Drive1 Submenu of the Main Menu
Menu Field Options Default Description
Type: • Auto
•None
[Auto]
NOTE: The Type field does not appear as a drop-down menu. Tap the
spacebar to toggle the selections.
Selects the ATA/ATAPI device type. Select Auto to have the type automati-
cally identified by the BIOS at POST. If None is selected, all of the following
setup items do not appear.
Multi-Sector
Transfers:
• Disabled
• 2 Sectors
• 4 Sectors
• 8 Sectors
• 16 Sectors
[Disabled] The best option is selected by the BIOS automatically when Auto is
selected and cannot be selected by the user. Specifies the number of
sectors per block for multiple sector transfer.
LBA Mode
Control:
• Disabled
• Enabled
[Disabled] The best option is selected by the BIOS automatically when Auto is
selected and cannot be selected by the user. Enables or disables Logical
Block Addressing in place of Cylinder, Head, Sector addressing.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select Serial ATA/IDE
drive installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
[None]
The drive is disabled.
Primary Master [None]
Type: [Auto]
Multi-Sector Transfers: [Disabled]
LBA Mode Control: [Disabled]
Transfer Mode: [Standard]
Ultra DMA Mode: [Disabled]
▲
Main Menu