Stud Sensor User Manual

SK-TSC-1125S User Guide

1 Overview

1.1 Abstract

The SK-TSC-1125S Starter Kit allows easy evaluation of the FMA1125 Touch Sensor

Controller. It consists of the following parts:

• 1x SK-TSC-1125S-TB touch board with FMA1125 TSC

• 1x ADA-16FX-TSC-LCD

• 1x 10-pin ribbon cable

• 3x FMA1125DC-24S Sample

• In order to use the free example software, an SK-16FX-EUROSCOPE Starter Kit

is required as host system, which has to be ordered separately. In this case,

the included ADA-16FX-TSC-LCD and ribbon cable can be used to connect

both PCBs.

• The SK-TSC-1125S-SB itself can alternatively be connected to any suitable

host PCB using appropriate connections.

A demo firmware allows direct evaluation of the touch sensor, and provides various

commands to tune the TSC parameters using a command-line interface and a terminal

program. The newest version of the demo firmware, the SK-Wizard (the recommended

terminal program) and additional information can be downloaded from the TSC product

page:

http://www.fujitsu.com/emea/services/microelectronics/tsc/

This manual will describe the behaviour when used with the above demo firmware where

needed (e.g. tuning with command line interface). Of course the Starter Kit itself can also be

used with different host software and / or hardware combinations.

This evaluation system must only be used for test applications

in an evaluation laboratory environment!