User's Guide

9
Getting Started
Table 1-2. System Status Indicators
Battery
• On State
• Idle Mode
Green, continuous Battery charge is between 50%-100%
Amber, continuous Battery charge is between 13%-49%
Red, continuous Battery charge is between 0%-12%
Red, blinking There is a battery error.
• Suspend-to-RAM,
without AC adapter
• Suspend-to-RAM
with AC adapter
Green, blinking slow Battery charge is between 50%-100%.
Amber, blinking slow Battery charge is between 13%-49%.
Red, blinking slow Battery charge is between 0%-12%.
•Hibernate
(Save-to-Disk),
with AC adapter
• Off State
Off Battery is not installed, or system is off or in
Hibernate mode.
•Hibernate
(Save-to-Disk),
without AC adapter
If battery is inserted during power off, LED blinks
amber for 4 seconds to detect battery. Battery
status is displayed for 5 seconds after that.
HDD
Access
• On State (or
flashing)
• Idle Mode
Green Displayed when hard disk drive is accessed.
• Suspend-to-RAM
•Hibernate
(Save-to-Disk)
• Off State
Off Hard disk drive is not being accessed.
Security
• On State Green, continuous
(until password is
entered)
The Security Indicator lights (if a password was
set) when the system resumes from Off or
Standby modes. You must enter the password
that was set in the Security Panel before your
system will resume operation.
In the following table, a “blinking” LED flashes at the rate of once per second; an LED that is “blinking, slow” flashes at the
rate of one second on, five seconds off.
Icon Mode/State LED State Remarks
Ocampa2_UG.book Page 9 Thursday, February 19, 2004 5:23 PM