User's Manual
Table Of Contents
- SPARC® Enterprise T5140 and T5240 Servers Installation Guide
- Contents
- Figures
- Tables
- Preface
- Preparing for Installation
- Installing the SPARC Enterprise T5140 and T5240 Servers
- Powering On the System
- Updating the Firmware
- Selecting a Boot Device
- Installing the Servers With the Express Rail Rackmounting Kit
- Index
16 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
Note – The procedures in this chapter are the same for both the 1U and 2U servers.
The illustrations show a 2U server only as an example.
The rackmount kit (same for both 1U and 2U servers) contains two slide rail
assemblies, which can be installed on either the right or left side of the rack. A slide
rail assembly consists of two parts: a slide rail and a removable mounting bracket.
The slide rail attaches to the rack posts. The mounting bracket attaches to the server
chassis. See “Slide Rail Assembly Notes for Both Servers” on page 10 for more
information about slide rail assemblies.
▼ To Install the Slide Rail Assemblies
1. Pull both mounting brackets completely out of their respective slide rails.
a. Simultaneously press and hold the upper and lower lock buttons of the
slide rail lock (
FIGURE 2-1).
FIGURE 2-1 Unlocking the Slide Rail Assembly (Either Server)
b. Pull the mounting bracket out until it locks in the extended position.