Datasheet

System configurator and order-information guide
B
PRIMERGY TX100 S3p Status 2012-04-30
Section
II
Processor
One of following CPU´s has to be selected
for an orderable basic unit
Dual-Core CPU`s
- 1x 64-bit Intel
Celeron (2MB SLC), Pentium (3MB SLC) or Core-i3 (3MB TLC)
occupies socket for one CPU
Celeron
Celeron G550 2.60GHz 2MB 2C/2T 1066MHz (65W) S26361-F3579-E255 on special release
Pentium
Pentium G640 2.80GHz 3MB 2C/2T 1066MHz (65W) S26361-F3579-E264
Core i3
Core i3-3220 3.30GHz 3MB 2C/4T 1333MHz (55W)
S26361-F3580-E222
Quad-Core XEON CPU`s
- 1x 64-bit Intel Xeon UP (8MB shared TLC = Third Level Cache)
Hyper-Threading; 1600 MHz DDR3 Bus and heat pipe
occupies socket for one CPU
Xeon E3-1220v2 3.10GHz 8MB 4C/4T 1600MHz Turbo (69W) S26361-F3580-E322
Xeon E3-1230v2 3.30GHz 8MB 4C/8T 1600MHz Turbo (69W)
S26361-F3580-E323
Xeon E3-1240v2 3.40GHz 8MB 4C/8T 1600MHz Turbo (69W) S26361-F3580-E324 on special release
Section
III
Memory
There are 2 memory banks with 2 DIMM slots each.
Single channel memory configuration allow maximum flexibility:
Additional memory can be configured as single memory modules.
Dual channel memory configurations for maximum performance:
For optimum performance memory has to be configured in pairs of memory modules with identical size.
max. 32GB unbuffered DDR3 RAM for UDIMMs with 8GB modules
Note**: Memory is not included in the base unit and has to be configured separately, min 1x.
Unbuffered (ub) DIMMs
- One DDR3- ub ECC memory module, 1.5V
Memory 2GB 1600 MHz
S26361-F3719-E513
4x
Memory 4GB 1600 MHz
S26361-F3719-E514
Memory 8GB 1600 MHz
S26361-F3719-E515
Choose up to 4 order codes above.
Section
IV
Graphics
Graphics Controller ATI ES1000 on board with 64 MB attached Memory
S26361-F2748-E537
PY VGA LP card 512MB PCI-e x1
NVIDIA NVS300 The hight end optional NVIDIA NVS300 graphic card offers dual head operation
512 MB PCIe-x1
and fully 3D video support.
2x DVI or 2x VGA or The cables for either two times DVI or VGA connections are part of the delivery.
1x DVI plus 1x VGA Remote Video direction via iRMC must be disabled.
cables adapters included
This PCIe-x1 card can also be installed in any PCIe-x4, x8 or x16 slot.
Dual head + fully 3-D
Only one card per server is allowed.
supported for Windows OS
only native driver support for Linux OS
PY VGA card must be installed in slot 2
full high bracket
S26361-F2748-L537
max. 1x per system
PY VGA LP card 512MB PCI-e x1
for loose delivery
C
Fujitsu Technology Solutions x86 PRIMERGY Server 8 of 13