Technical data

Important notes

FCC Compliance Statement

If th e device complies with the FCC regulations, the FCC sign can be found on the type rating plate.

FCC Class B Compliance State

ment

DOC ( INDU STRY CANA DA) NOTICES

Notice to Users of Radios and Television:

This class B digital a pparat us complies with Canadian I CES-003.

The following statement applies to the pro duct s covered in this manual, unless otherwise speciﬁed

herein. The statement for other products will appear in the accompanying documentation.

NOTE:

This equipment has been tested and found to comply with the limits for a "Class B" digital

device, pursuant to Part 15 of the FCC rules and meets all require ments of th e Canadian

Interference-Causing E quipment Standard ICES-003 for digital app aratus. These limits are

designed to provide reasonable protection against harmful interference in a residen tial installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in strict accordance with the instructions, may cause harmful interference to radio

communications. However, there is no gu arantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to r adio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the s

eparation between equipment and the rece iver.

• Connect the equipment into an outlet on a circuit different from th at to

which the receiver is connected.

• Consult the d

ealer or an experienced radio/TV technician for help.

Fujitsu is not responsible for any radio or tel evision interference caused by unauthorized

modiﬁcations of this equipment or the substitution or attachment of connecting cables and

equipment other than those speciﬁed by Fujitsu. The c orrection of interferences caused by such

unauthorized mod iﬁ cation, substitution or attachment will be the responsibility of the user.

The use of shielded I/O cables is required when connecting this equipment to any and all optional

peripheral or host devices. Failure to do so may violate FCC and ICES rules.

12 Fujitsu