Technical data

System expansio ns
Installing an accessible drive
► Open the casing (see "Opening the casing", Page 36).
► If you are installing th e drive in the upper bay and a cover (optional) is
already in place, please remove it.
or
► If you are installing the drive in the lower bay and a cover (optional) is
already in place , please remove it.
► Break out the pre-stamped metal cover on the drive bay.
► Fit the drive cover for the 5
1
/
4
inch dri ve (see " Fitting the drive cover for
the 5
1
/
4
inch drive", Page 38).
Do not throw away the cover. For cooling and protection a gainst fire you m us t refitthe
cover if you remove the drive again later (see "
Removing an accessible drive", Page 40).
1
► Slide the accessible drive into the casing until it snaps in place (1).
► Connect the cables to the drive. Make sure the polarity is correct.
► Close the casing (see "
Closing the casing" , Page 37).
It may be necessary t o modify the entry for the drive in the BIOS Setup.
Fujitsu 39