User's Manual

60 - Troubleshooting
The battery seems to
discharge too quickly.
(continued)
You’re running an application
that uses a lot of power due to
frequent drive access, or use of
wireless devices.
Use a power adapter for this application when at all possible.
The battery is too hot or too
cold.
Restore the Hybrid Tablet to normal operating temperature. Charging icon on the Sta-
tus Indicator panel will flash when battery is outside of operating range.
Shutdown and Startup Problems
The Suspend/Resume
switch does not work.
Suspend/Resume
switch is disabled.
To enable the button, go to Control Panel -> Power Options and click on the Advanced
tab. In the Power buttons area, select the “Change what the power button does”
option.
There may be application soft-
ware. conflict
Close all applications and try the button again.
The system powers up and
displays power on informa-
tion, but fails to load the
operating system.
You have a secured system
requiring a password to load
your operating system.
Make sure you have the right password. Enter the setup utility and verify the Security
settings and modify them as accordingly.
See “BIOS Setup Utility” on page 39.
The boot sequence settings of
the setup utility are not compat-
ible with your configuration.
Set the operating source by pressing the [F12] key while the Fujitsu logo is on screen
or use the [F2] key and enter the setup utility and adjust the source settings from the
Boot menu.
See “BIOS Setup Utility” on page 39.
Hard drive was not detected. Use BIOS setup utility to auto detect the internal hard drive.
An error message is dis-
played on the screen during
the boot sequence.
Power On Self Test (POST) has
detected a problem.
See the Power On Self Test (POST) messages to determine the meaning and severity
of the problem. Not all messages are errors; some are simply status indicators.
See
“Power On Self Test Messages” on page 62.
Your Hybrid Tablet appears to
change setup parameters
when you start it.
BIOS setup changes were not
saved when made and you
exited the setup utility.
Make sure you select Save Changes And Exit when exiting the BIOS setup utility.
Problem Possible Cause Possible Solutions