User's Manual

46 - Using the Touch Screen
Calibrating the Touch Screen
In order to ensure accurate tracking between the stylus and cursor, you must run the Tablet Calibration
utility before you use the Touch Screen for the first time, or after you change the display resolution.
To run the calibration utility:
1 Go to Start -> Control Panel. If you are not in Classic View, select Switch to Classic View in the left panel.
2 Double-click the Tablet Calibration icon.
3 Adjust the display of your notebook to a comfortable angle.
4 Touch the stylus to various points on the screen to verify that the screen is correctly calibrated.
Dragging
Dragging means moving an item with the stylus by
touching the screen, moving and then lifting the stylus.
To drag, touch the Touch Screen with your stylus on
the item you wish to move. While continuing to touch
the screen with the stylus, drag the item to its new
location by moving the stylus across the screen, and
then lifting the stylus to release it. Dragging can also
be done using your fingertip.
Figure 24. Dragging on the touch screen
DO NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION. USE OF
EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE LED AND/OR TOUCH PANEL.
W
HEN USING THE STYLUS TO CALIBRATE THE SCREEN, BE SURE TO AVOID TOUCHING THE SCREEN
WITH YOUR FINGERS; DOING SO COULD RESULT IN FAULTY CALIBRATION.