User Manual

3
−
17
− To Measure the BP −
1. Connect the 2ch BP conversion cable to the monitor and interface cable.
2 channels of BP can be measured on this monitor.
Connect the monitor and the interface cable via
2ch BP conversion cable.
2. Assemble the BP measurement device.
The following procedure explains the case when BP transducer (COBE CDX series, No.041-575-
504) is used.
If using other transducers, refer to the operation manual for the corresponded transducer.
(1) Check if the package of the transducer is not
damaged before opening.
Verify that each connector is securely connected.
(2) Align the bracket to patient’s heart position (about
1/2 of the chest depth).
2ch BP Conversion Cable
Interface Cable
3
To Measure the BP