User's Manual

−

Connection to the Patient Monitor

1. Connect the lead cable to the electrode.

Clip on the lead cable end to the electrode convex

part.

CAUTION

The indication for continuous use of the electrode is about one day.

Replace the electrode if the skin contact gets loosen due to perspiring,

etc.

When an electrode is attached at the same location for a long time,

some patients may develop a skin irritation. Check the patient’s skin

condition periodically and change the electrode site as required.

2. Connect the lead cable to the relay cable.

3. Plug in the relay cable to the ECG input connector (green) of the patient monitor.

4. Verify that the ECG waveform is displayed on the monitor.

Adjust the waveform size and position. The

monitoring lead can be also changed.

Reference

Refer to “ 6. Parameter Setup ECG” for size / lead setup.