User Manual

4
−
14
●
Equipment Status Alarm Message
The equipment status alarm message will be displayed when proper monitoring can not be
performed. The alarm message will be displayed according to the priority of the alarm level. If
more than one alarm with the same level is generated, the alarm message for the newer alarm will
be displayed.
Cautionary Alarm (Alarm Level 2)
Item Message
Battery “Charge battery”
ECG
Impedance Respiration
“Check electrodes
“Check SpO
2
sensor”
SpO
2
“SpO
2
sensor fault”
“Check filter line”
CO
2
“CO
2
unit error”
”ECG not connected”
”BP not connected”
”SpO
2
not connected”
”TEMP not connected”
Connector Off
”CO
2
not connected”
NOTE
The “Connector Off” alarm can be cancelled by pressing the Alarm Silence
key. Before silencing the alarm, make sure that the disconnected connector is
unnecessary.
Treatment Needed Alarm (Alarm Level 3)
Item Message
NIBP “Check NIBP hose”
Impedance Respiration “CVA detected”
SpO
2
“No pulse detect”
ECG “Pacemaker error”
Notification Alarm (Alarm Level 4)
Item Message
“Wave freeze”
“Touch key OFF”Operation
“Night mode”
“ECG failed”
ECG
“Artifact”
“BP1 transducer OFF”
“BP1 not zero balanced”
“BP2 transducer OFF”
“BP2 not zero balanced”
BP
“Incorr. BP cable”
Equipment Status
Alarm Message