User Manual

4
−
18
Freeze
Temporarily stops the waveform trace. By pressing the
Rec. START/STOP key during freeze mode, the waveform in
freeze mode can be recorded.
NIBP Auto Mode Displays the NIBP measurement interval setup menu.
Lead
・
Size
Displays the keys to adjust the size, scale, baseline position of
the displayed waveform.
HR Source
Sequentially selects the HR source in the order of ECG
→
SpO
2
→
BP1
→
Auto
→
ECG.
Tone/Volume Displays the tone/volume setup menu.
Other Bed Displays the other bed display menu.
Record Displays the recording setup menu.
Display Config. Displays the display configuration menu.
ST Display Displays the ST measurement menu.
Night Mode Turns ON / OFF the night mode.
BP Zero Performs zero balance of BP1, BP2.
OFF User key will not be set.
4. Repeat the procedure 2, 3 and set the remaining user keys.
5. Initialize the user key setup.
Pressing the Initial key for more than 2 seconds
will initialize the user key setup to factory setting.
The factory setting is as follows.
User Key 1: Alarm Silence
User Key 2: Rec. START/STOP
User Key 3: Lead
・
Size
User Key 4: Admit / Discharge