User Manual

4
−
3
●
To Configure the Display
The waveforms and numeric data to be displayed can be selected as desired.
CAUTION
When performing telemetry transmission, the numeric data corresponding
to the waveform should be selected for display. Otherwise, the displayed
waveform or numeric data may not be transmitted.
1. Press the Menu
→
Display Config.
keys.
The display configuration menu will be displayed.
＜
Display Config. / Meas. Selection
＞
2. Select the parameters for numeric data display.
Up to 7 parameters can be selected. The displaying
order can not be selected.
It will be automatically positioned in the order of
HR (PR, BPR)
, VPC/ST , BP , NIBP ,
SpO
2
, TEMP , RR , TEMP/RR , EtCO
2
from the top.
The displayed size of each parameter will be
determined by the number of selected parameters.
If HR display is not selected, VPC/ST
will be
displayed at the bottom row.
Selecting TEMP/RR will display TEMP and RR
numeric data in half size inside one parameter box
which allows to display up to 8 numeric data.
To display 8 numeric data, select TEMP/RR
and 6
other parameters.
＜
8 Numeric Data Display
＞
3. Select ON or OFF to enlarge the numeric data display or not.
Select ON to have the numeric display enlarged
on the first display when the power is turned ON.
Selecting OFF
will display the numeric data in a
standard size.
4. Select the waveforms and positions for display.
Press the Wave key to display waveform
selection menu.
4
Display Configuration