User Manual

−

− Suspend Monitoring − Suspend and Resume Monitoring

This menu allows to suspend and resume monitoring when a patient temporarily leaves the bed.

Turning the power OFF will erase the recall and ST measurement data, but with this suspend

monitoring function, data measurement, alarm generation, automatic measurement, and

automatic recording can be suspended without erasing any data and setup condition.

To Suspend Monitoring

1. Press the Cease key.

The confirmation menu will be displayed. If the Cease

key is pressed by mistake, press the

Cancel

key to return to the previous display.

2. Confirm the monitoring suspension.

Pressing the OK

key will return to the home display with the Resume key displayed.

The numeric data display and waveform display on the home display will be suspended and only

the Resume key will be effective.

NOTE

The telemetry transmission will cease when monitoring is suspended.

Note that the square wave will be displayed on the central monitor indicating the

too far condition of the telemetry.

Suspend Monitoring