User Manual

4
−
9
Temperature Value
Displays the temperature measurement value. The YSI-400 temperature sensor can be used.
When the measurable range is exceeded, “
× × ×
” will be displayed. When the YSI-700 is used,
“
ｰ ｰ ｰ
” will be displayed for the measurement value.
RR Value
Displays the impedance RR / CO
2
RR measurement value corresponded to the respiration
synchronization source. When the measurable range is exceeded, “
× × ×
” will be displayed.
When the ECG relay cable for electrosurgical knife is used, or when impedance measurement is
set to OFF, impedance RR will not be displayed.
EtCO
2
/ InspCO
2
Value
Displays the end-tidal CO
2
concentration and inspiratory CO
2
concentration measurement value.
The measurement unit can be selected from mmHg / kPa / % on the CO
2
configuration menu.
RR Parameter
Displays the parameter measuring the RR.
By switching the RR synchronization source, selection from impedance respiration rate (RR_IMP),
CO
2
respiration rate (RR_CO
2
) can be made.
RR Synchronization Mark
Displays the synchronization mark corresponding to the RR parameter.
VPC Value (1 minute)
Displays the VPC rate for the last 1 minute.
”
ｰ ｰ ｰ
” will be displayed during arrhythmia learning.
ST1, ST2 Level
ST levels for ECG1 and ECG2 will be displayed.
”
ｰ ｰ ｰ
” will be displayed during arrhythmia learning, lead-off condition, and when reference
waveform is not set for ST measurement.
Pace Beats (1 minute) / Total Beats (1 minute)
Pace beats and total beats for the last 1 minute will be displayed.
”
ｰ ｰ ｰ
” will be displayed during arrhythmia learning.
4
Display Configuration
4
VPC Value (1 minute)
ST
１ Level
Pace Beat (1 minute)
ST2 Level
Total Beats (1 minute)