User's Manual

xviii
Precautions for Use of SpO
2
Sensor
DANGER
Burn Risk in Using SpO
2
Sensor
In SpO
2
monitoring, always use the sensor/relay cable specified by Fukuda
Denshi. If any other sensor/relay cable is used, a high temperature rise of
the sensor may place the patient in danger of burns.
If there are any questions regarding the sensor/relay cable use for SpO
2
measurements of this device, please contact Fukuda Denshi service
representative.
Precautions for Use of NIBP Cuff
CAUTION
This product contains natural rubber latex which may cause allergic reactions.
Disposing of Equipment, Accessories, or Components
CAUTION
When disposing of the equipment, accessories, or components, use an
industrial waste distributor. Do not dispose of as ordinary waste.
Precautions about Transportation
For transporting the DS-7100 system, pack with specified packing materials.
Reference
Refer to “11. Technical Information Specification / Performance” for environmental condition
during transportation.
Precautions about RTC or Data Backup
CAUTION
?
The DS-7100 system is equipped with a built-in clock. When the power of
the DS-7100 system is turned off, this clock is backed up by a lithium primary
battery.
If incorrect time is displayed when turning on the power, a low battery may be
the cause. In such case, contact Fukuda Denshi service representative for
replacing the battery.
?
To protect the data during voltage dip, short interruptions and voltage
variations on power supply input lines or during short duration of power
turned OFF, this monitor performs 5-minute (approx.) data backup using the
secondary battery. The data may not be protected if the power is turned off
within 30 minutes from power on.