Users Manual

6. SpO

Monitoring

●Applying the LNCS inf-L, LNCS inf-3, RD SET Inf

1. Open the pouch and remove the sensor. Remove the backing from the

sensor, if present.

2. Direct the sensor cable so that it either points away from the patient or

runs along the bottom of the foot. Position the detector onto the fleshy

part of the great toe (Fig 1). Complete coverage of the detector window is

needed to ensure accurate data.

3. Wrap the adhesive wrap around the toe and ensure that the emitter

window (red star) aligns on the top of the toe directly opposite the detector

(Fig. 2).

Verify correct positioning and reposition if necessary (Fig. 3).

●Applying the LNCS Neo-L, LNCS NeoPt-L, LNCS NeoPt3,

RD SET Neo, RD SET NeoPt

1. Open the pouch and remove the sensor. Remove the backing from the

sensor, if present.

2. For fragile skin, the stickiness of the medical grade adhesive can be

diminished or eliminated by daubing the adhesive areas with a cotton ball

or with gauze (Fig. 1).This step does not apply to the NeoPt 500.

3. Direct the sensor cable so that it either points away from the patient or

runs along the bottom of the foot. Apply the detector onto the fleshy part

of the lateral aspect of the sole of the foot aligned with the fourth toe (Fig.

2). Alternatively, the detector may be applied to the top of the foot (not

shown). Complete coverage of the detector window is needed to ensure

accurate data.

4. Wrap the adhesive/foam wrap around the foot and ensure that the emitter

window (red star) aligns directly opposite of the detector. Be careful to

maintain proper alignment of the detector and emitter windows while

attaching adhesive/foam wrap to secure the sensor (Fig. 3).

Verify correct positioning and reposition if necessary. (Fig. 4).