Installation Manual

EN
3
STEP 2 - EXHAUST DUCT ASSEMBLY
INSTALLATION
1. Place the Exhaust Duct Assembly in the center of the
opening. Align the front edge of the duct with the front
of the cabinet.
2. Secure the Exhaust Duct Assembly with two Screws D.
See Sketch 3.
Exhaust duct assembly
right side aligns to front
edge of shelf
Screw D
Screw D
Sketch 3
STEP 3 - FRAME INSTALLATION
1. Place the oven adjacent to the wall or cabinet opening.
Plug the power cord into the electrical outlet.
2. Carefully guide the assembled oven into the prepared
opening. Slide the oven on the Exhaust Duct Assembly.
See Sketch 4. Avoid pinching the cord between the
oven and the wall. Adjust the position of the oven so
that the feet of the oven are fitted into the recesses of the
Exhaust Duct Assembly and door will open properly. See
Sketch 5.
Sketch 4
Exhaust
duct
assembly
Foot
Duct recess
Sketch 5
3. Disassembly: The Front Frame and Back Frame come
pre-assembled with ball studs engaged in the receivers.
Separate the Front Frame from the Back Frame. Place
the assembly face down on a protected surface. At the
location of the ball stud, insert a flat head screwdriver
between the Front Frame and the Back Frame and gently
pry up to disengage the ball stud from the receiver.
Repeat for each corner. See Sketch 6.
Sketch 6
Standard Installation Guide