Installation Manual

6 - Conversion for LP or NG Gas

Converting Appliance for Use with LP

Gas

WARNING

Conversion is to be performed by an AUTHORIZED

SERVICER (or other qualified agency) in accordance

with the manufacturer’s instructions and all codes and

requirements of the authority having jurisdiction. Failure to

follow instructions could result in serious injury or property

damage.

The qualified agency performing this work assumes

responsibility for this conversion.

CAUTION

Before proceeding with the conversion, shut

off the gas supply to the appliance prior to

disconnecting the electrical power

If this appliance is to converted for use with gas LP (propane

or butane), each of the following modifications must be

performed:

Gas conversion label (aluminium) to be placed on the back

of the appliance, near the data plate, after conversion has

been carried out;

Replace Injectors (two ring ﬂame burner)

1. Remove the grates and burner caps.

2. Remove aluminium gas spreader.

3. Remove the three screws from the simmer gas spreader

(1).

4. Remove the two screws of the injector cover (2).

5. Remove injector (A) by using a 9-32” (7 mm) nut driver

counter clockwise.

6. Remove injector (B) by using a 9-32” (7 mm) box wrench

counter clockwise.

7. Install the injectors supplied with this appliance in the

appropriate burner. The injectors have small numbers

stamped on the side, this number corresponds with the

orifice diameter and its correct burner location (refer to

illustrations in the section: “Injectors Position”).

8. Turn clockwise to tighten (tighten to a torque of 15 to 20

inch-lbs).

9. Replace all parts following the reverse order.

10. Save the injectors removed from the appliances for

future use.

EXPLODED VIEW OF BURNER