Installation Manual

ManualsBrandsFulgor Milano ManualsCooking Appliances48 Inch Gas Rangetop with 6 Sealed Burners, Continuous Cast Iron Grates, Black Enameled Surface, Dual Crescendo Burner, Electric Re-Ignition System, Flame-Out Sensing, Top Mount Injectors, and Trilaminate Stainless Steel Griddle

6 - Conversion for LP or NG Gas

Proceed to Pressure Regulator Conversion

noting the LP / Propane position to comple-

te the conversion.

After replacing the injectors adjust the burner flame (see

Low Flame Adjustment paragraph).

Check the appearance of each burner’s flame at HILO

settings, if the flame appears too large or too small make

sure that all steps were completed correctly.

Converting Appliances for Use with NG

Gas

If this appliance should be converted for use with gas NG

(natural gas), each of the following modifications must be

performed.

1. Convert the pressure regulator to NG position as per the

section “Pressure Regulator Conversion”.

2. Replace all injectors following the step described on the

previous pages, observe the number stamped on the

side, this number corresponds to the orifice diameter

and its correct burner location (refer to the illustrations in

section: “Injectors Position”).

3. Adjust the burner flame (see Low Flame Adjustment

section).

Check the appearance of each burner’s flame at HI - LO

settings, if the flame appears too large or too small make

sure that all steps were completed correctly.

Pressure regulator conversion

The appliances is designed for use with NG gas or LP gas.

The gas pressure regulator is supplied. It must be installed in

the gas supply line ahead of the manifold entrance.

It is pre-set for use with the gas as indicated on the appliance

label supplied with the appliance. For use with different gas

the appliance must be converted.

For the pressure regulator conversion follow the instructions

below:

• Disconnect all electrical power, at the main circuit breaker

or fuse box.

• Shut off the gas supply to the cooktop by closing the

manual shut-off valve.

• Adjust the pressure regulator, by following the instruction

(see figure)

1. Unscrew the regulator cap

2. Unscrew the plastic conversion plug from the cap turn

over and screw back (wide section away from cap for

LP and against cap for NG) see figures below.

3. Replace the regulator cap ensuring gasket is in place.

PRESSURE REGULATOR CONVERSION

NG POSITION

PLUG

PRESSURE REGULATOR

LP/PROPANE POSITION

GASKET

CAP

Before replacing the regulator cap, check if the position

of plug is suitable for the gas