Installation Manual

EN
20
6 - Conversion for LP or NG Gas
Replace Injector (griddle)
1. Remove griddle plate.
2. Remove the burner fixing screw (1).
3. Remove the springs (2) from thermocouple and ignitor
to shift the burner.
4. Remove injector (A) by using a 9-32” (7mm) nut driver
counter clockwise.
5. Install the injector supplied with this appliance. The
injector has small numbers stamped on the side, this
number corresponds with the orifice diameter.
6. Turn clockwise to tighten (tighten to a torque of 15 to 20
inch-lbs.)
7. Replace all parts following the reverse order.
8. Save the injectors removed from the appliances for
future use.
EXPLODED VIEW OF BURNER
2
1
A