User Manual

235
7
111
12
6
9
8
end
10
Sanitized
1/2
160°F
4
IMPORTANT!
The dishwasher door must be closed within 4 seconds after selection of the pro-
gram to start the wash cycle. Otherwise, 4 seconds after selection the program light
starts to flash quickly to indicate that the selected program must be confirmed.
Press the program selection button once; the light stops flashing. Close the door at
once to start the wash cycle.
Close the door within 4 seconds or confirm the start (program selection button) and
close the door.
2.2.2 Selecting and starting the program
• Press the program selection button (ref. 3) several times until the indicator light
corresponding to the required program turns on (ref. 2)
• If required, press the relative buttons to select any complementary functions
(e.g.: “extra drying”, “program delay”; see parag. 2.2.7 “options”);
• Close the door within 4 seconds or confirm the start (program selection button)
and close the door. The program will start after about 2 seconds and the relevant
indicator light will flash throughout the cycle (program running signal).
If the door of the dishwasher has not been closed or has been incorrectly
closed, the washing cycle will not begin.
FAST CYCLES OPTION
• Select this option together with any washing program (except the soak program)
to SHORTEN the cycle by a minimum of 10% to a maximum of 55%, depend-
ing on the cycle selected. To activate this option, press the FAST CYCLES button
(light comes on) after selecting the program required. The option is auto-
matically deactivated at the end of the program.
2.2.3 End of the program
The end of the program i signaled by a short beep. Additionally the indicator light of
the normal and strong programs (marked “end”) flash.
2.2.4 Interrupting a program
To interrupt the current program simply open the door of the dishwasher; to restart
the program, close the door within 4 seconds or confirm the start (program selec-
tion button) and close the door. The program restarts from where it was interrupted.
2.2.5 Changing the current program
To modify the current program, simply open the door (look out for splashes!) and se-
lect the new program. Close the door within 4 seconds or confirm the start (program
selection button) and close the door.
10
USER INSTRUCTIONS
EN