Install Guide

EN
14
Show date
Using this function it is possible to deactivate/acti-
vate the date visualization on the display.
How to activate the date
How to deactivate the date
DATE
Set date
The display will show the date in the format
dd:mm:yy (day:month:year), the day will blink. Use
the Up/Down buttons
to modify the setting, con-
firm with Enter
to go on to the next setting; once
the year is confirmed the date will be set.
How to set the date
TIME
Set time
The display shows the hours and minutes in the for-
mat hh:mm and with hh: blinking. Use the Up/Down
buttons
to modify the setting and then confirm by
pressing Enter
to go on to the next setting.
Once the minutes are confirmed, the time will be
set.
How to set the time
Set 12/24
This function selects the display at 12 or 24 h.
How to set the display to 12 h
Repeat the operation until the water is clean.
Correctly position the ice tray or another sui-
table container under the IceMaker to collect
water, then close the drawer. At the end of the
operation, wash the tray.
5.3 Basic settings of the Menu
Select the Menu button and used the Up/Down
button
to select Settings .
Fresh Zone Options
The freezer compartment can, if required, be con-
verted to the refrigeration o Fresh operating mode.
Default Setting
This oers the possibility to reset default factory
settings and cancels any previous changes.
How to set the Fridge function
How to set the Fresh function
How to revert to the Freezer function
How to reset default settings
Important
If the default settings are restored, the de-
fault mode of the Fresh Zone compartment
is freezer mode. If it was previously being
used in refrigerator or Fresh mode be sure
to set it back to your desired setting.