Installation Manual

EN
11
Drawer Panel
• When preparing the Drawer Panel, follow the same
instructions as per the door panel, but make sure
measurements are taken starting from the top edge [ 7 ].
The height-adjustment support brackets are oriented the
opposite way [ 8 ] (note imgs 4 and 8).
7
8
• Prepare the appliance door (and drawer(s) if applicable)
for panel mounting by threading the shoulder bolts into
the recessed receivers and the set screws into the other
hole [ 9 ]. Ensure the end with the hex key socket is
threaded into the door and not on the visible end. Thread
this in far enough that it is flush with appliance door face
so as not to interfere with hanging the panel. You will
adjust these later.
9