Installation Sheet
ENGLISH
Installation Manual
5
Figure 3. Cutout dimensions and requirements
D
G
C
E
F
COTOUT REQUIREMENTS
WALL COVERING CABINETS,
AND COUNTERTOP MUST
WITHSTAND HEAT UP TO 93° C (200° F)
CUTOUT
WIDTH
ABCDEFG
24” (60 cm)
22 5/8”
(57,4 cm)
22 13/16”
(58,0 cm)
19-1/4”
(49.0 cm)
19-9/16”
(49.7 cm)
24”
(60 cm) min
18” (45.7 cm)
min
Height from
countertop
to nearest
cabinet on
either side of
unit
30” (76.2 cm)
min.
(see note*)
Clearance
from
countertop to
unprotected
overhead
surface
2” (5 cm) min
Clearance
from cutout to
side wall on
the left and
right of the
unit
13” (33 cm)
Depth of
unprotected
overhead
cabinets
30”
(76.2cm)
28-11/16”
(72.9 cm)
28 15/16”
(73.5 cm)
19-1/4”
(49.0 cm)
19-5/8”
(49.8 cm)
30”
(76.2 cm) min
36”
(91.4 cm)
34-1/16”
(86,5 cm)
34-5/16”
(87.2 cm)
19-1/4”
(49.0 cm)
19-5/8”
(49.8 cm)
36”
(91.4 cm) min
IMPORTANT
Under the cooktop it is necessary to install a partition as
shown in
* NOTE
24” (61 cm) min. clearance if bottom of wood or metal
retardant millboard covered with no less than No. 28 MSG
sheet steel 0.015” (0.04 cm) stainless steel, or 0.024” (0.06
cm) aluminum or 0.020” (0.05cm) copper.
30”(76.2 cm) min. clearance between top of cooking platform
and bottom of unprotected wood or metal cabinet
Important Preparation Suggestions
1. Chamfer all exposed edges of decorative laminate
to prevent damage from chipping.
2. Radius corners of cutout and file to Insure
smooth edges and prevent corner cracking.
Recommend 1/4“or 3/8“diameter drill In each
corner.
3. Rough edges, inside corners which have not been
rounded and forced fits can contribute to cracking
of the countertop laminate.
This cooktop has been designed with wide
tolerances of cut-out to cover possible
replacement with other brands. We recommend to
that you consider the minimum dimension of cut-
out size In the case of new Installation.
Some cut out sizes for possible replacements:
Dim . Inches cm
• 24” 22 13/16” x 19-9/16” 58,0 x 49,7
• 30” 28-15/16” x 19-9/16” 73,5 x 49,7
• 36” 34-5/16” x 19-9/16” 87,2 x 49,7