User manual

This setting is only relevant when the device is controlled via DMX.
Press [MODE] repeatedly until the display shows ‘dxxx’ . Press [SETUP]. With [UP] and [DOWN]
you can now select one of the following DMX operating modes:
n ‘2-ch’ (two channels)
n ‘3-ch’
(three channels)
n ‘5-ch’ (ve channels)
n ‘24Ch’
(twenty-four channels)
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE].
This setting is only relevant if the device is serving as Slave in a Master / Slave conguration
and is not controlled via DMX.
Press [MODE] repeatedly until the display shows ‘SLAv’ .
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE].
DMX mode
Operating mode ‘Slave’
Operating
LED BARbara 16 LED BARbara 24
35
LED Bar