User manual

6 Operating

Connect the device to the power supply to start operation.

Press [Mode] to activate the main menu and select an operating mode. Use [Up] and [Down] to

change the respectively displayed value.

6.1 Operating mode ‘Preprogrammed automatic show’

A preprogrammed automatic show can only be activated when the unit is operating in stand-

alone mode or as master in a master / slave combination. This setting is only relevant if the

device is not controlled via DMX.

1. Press [Mode] repeatedly until the display shows ‘AUTO’ .

The playback of the preprogrammed shows starts automatically.

2. Press [Setup] repeatedly until the display shows ‘SP.xx’ and adjust the programme run‐

ning speed with [Up] and [Down] in a range from ‘SP.01’ … ‘SP.FL’ (slow … fast).

3. Press [Setup] repeatedly until the display shows ‘F5.xx’ and adjust the frequency of the

strobe eect with [Up] and [Down] in a range from ‘F5.00’ … ‘F5.99’ (slow … fast).

Operating

LED Pot Strobe 100

Stroboscope