User manual

6.3 Operating mode ‘Slave’
This setting is only relevant if the device is working as Slave in a Master / Slave conguration
and is not controlled via DMX.
1. Press [Mode] repeatedly until the display shows ‘SLAv’ .
ð
The device is in Slave mode.
2. Use [Mode] to select any other operating mode to exit Slave mode.
6.4 Operating mode ‘Dimmer’
This setting is only relevant if the device is working as Slave in a Master / Slave conguration
and is not controlled via DMX.
1. Press [Mode] repeatedly until the display shows ‘Colr’ .
2. Use [Up] and [Down] to set the brightness of the LEDs in a range from ‘u.000’ … ‘u.255’ .
Operating
28
LED Pot Strobe 100
Stroboscope